Disassembly

1. Shift transaxle into neutral by inserting a drift pin into input shaft hole and positioning shaft in center detent position.
2. Loosen detent plunger retaining bolt and the detent plunger.
3. Remove shift fork interlock sleeve retaining pin, drain plug, then the clutch housing to transaxle case attaching bolts.
4. Separate case halves by tapping on transaxle case with plastic mallet. Do not pry case halves apart.

Reverse Idler Shaft & Gear Replacement:

5. Remove detent plunger retaining screw. Then remove detent spring and detent plunger using a magnet.
6. Remove case magnet.
7. Remove C-clip retaining ring from the fifth gear shift relay lever using a small screwdriver, then the fifth gear relay lever.

Five Speed Manual Transaxle Sectional View:

8. Remove reverse idler shaft and idler gear by lifting shaft upward.
9. Remove setscrew or roll spring pin from shift lever assembly.

Shift Lever Assembly Replacement:

10. Rotate shaft 90° to disengage reverse inhibitor plunger from detent notch in shift lever shaft. Slide shaft toward differential, then remove shift lever assembly.

Shaft Assemblies Replacement:

11. Remove mainshaft, input cluster shaft and main shift control shaft as an assembly.
12. Remove differential and final drive gear assembly from clutch housing case.