Shoulder Belt Retractor

Removal and Installation
1. Remove plug button at shoulder belt retainer anchor cover.
2. Disconnect shoulder belt anchor at retainer.
3. Remove emergency release lever handles.

NOTE: Relieve pressure of retaining clip on underside of handles, while gently pulling handles off.

4. Remove console retaining screws.
5. Remove armrest, if so equipped.
6. Disengage shoulder harness opening bezel from the console.
7. Remove the retractor.
8. To install, reverse Steps 1 through 7. Tighten retractor to floor brace retaining bolts to 30-43 Nm (22-32 lb-ft).