Braking Sensor/Switch: Adjustments

Fig. 2 Pedal Travel Switch Adjustment:

1. Push switch plunger completely into switch housing, this zeros out switch adjustment so it can automatically reset to correct dimension, Fig. 2.
2. Slowly pull arm back, out of switch housing past detent point. At this point it should be impossible to reattach arm to pin unless brake pedal is forced down.
3. Depress brake pedal until switch hook can be snapped onto pin. Snap hook onto pin and pull brake pedal back up to its normal position. This automatically sets switch to proper adjustment. When switch is unhooked from pin, the above resetting procedure should be performed to ensure correct switch adjustment.