With Digital Cluster

REMOVAL
1. Disconnect battery ground cable.
2. Remove two lower trim covers.
3. Remove steering column cover and disconnect two screws retaining PRNDL cable to cluster.
4. Remove cluster trim panel.

NOTE: Switch module must be disconnected from cluster to remove trim panel.

5. Remove four cluster retaining screws.
6. Pull bottom of cluster toward steering wheel.
7. Reaching behind and underneath cluster, disconnect three connectors.
8. Swing bottom of cluster out to clear top of cluster from crash pad and remove cluster.

INSTALLATION
1. Insert top of cluster under crash pad, leaving bottom out.
2. Connect three connectors.
3. Seat cluster and install four retaining screws.
4. Connect battery ground cable and check cluster operation.
5. Connect PRNDL. Check PRNDL dial alignment and adjust if necessary. Install steering column cover.
6. Connect switch module to cluster and install cluster trim panel.
7. Install two lower trim covers.