With Floor Shift

Interlock Cable Assembly

Floor Shift

Removal

1. Remove console.
2. Remove interlock cable to shifter retaining screw and remove cable from shifter interlock cam.
3. Remove LH lower instrument panel trim. Remove lower steering column shroud.
4. Remove steering column retaining nuts and lower column to floor.
5. Remove two interlock cable retaining screws from steering column.
6. Pull cable out from under instrument panel and unhook it from retaining bracket.
7. Roll back carpeting and slide cable out.


Installation

1. Route cable under carpeting. Position cable under A/C plenum bracket and under accelerator pedal.
2. Connect cable to shifter interlock cam and install retaining screw at shifter.
3. Install cable to steering column. Install two retaining screws. Tighten to 1.5 - 2 Nm (13 - 17 lb-in).
4. Position column to support bracket and install retaining nuts. Tighten to 20 Nm (14 lb ft).
5. Install column shroud and instrument panel trim panel.
6. Check for proper interlock operation. The ignition key should be removeable only with the shifter in PARK. The shifter should be locked in the PARK position with the key removed.