Ignition Lock Actuator & Steering Wheel Lock Pawl

Fig. 4 Steering Column Installation:

Fig. 5 Steering Column Exploded View:

Refer to Figs. 4 and 5 for component identification.

Removal

1. Remove lock cylinder housing, ignition lock switch, lock cylinder assembly and lock drive gear as described previously.
2. Slide actuator assembly out of the rear of the track in the lock cylinder housing.
3. Remove lock pawl and spring.

Installation

1. Install lock pawl and spring on actuator assembly.
2. Install actuator assembly into track on lock cylinder housing and install the lock drive gear and lock cylinder assembly.
3. Install ignition switch and lock cylinder housing.