Control Assembly: Service and Repair

1. Disconnect battery ground cable.
2. Remove storage compartment.
3. Remove heater/radio bezel.
4. Remove control panel retaining screws.
5. Lower glove compartment and remove upper support.
6. Disconnect air door control cable.
7. Disconnect function selector cable at heater assembly.
8. Remove LH center carpet panel.
9. Disconnect temperature control cable at heater assembly.
10. Pull heater control panel from I/P far enough to remove electrical connectors from rear.
11. Remove two screws and heater control panel assembly with cables attached.
12. Reverse procedure to install.