Bumper Insert Molding - Bulges At Outer Ends: Overview

90ford35 Article No. 90-22-4
^ BUMPER - FRONT AND REAR - INSERT MOULDING BULGE

^ EXTERIOR TRIM - BUMPER INSERT MOULDING BULGES
LINCOLN-MERCURY: 1991 CAPRI

Figure 1:

ISSUE: The bumper insert moulding may bulge at the outer ends of the bumper. This usually occurs between the end of the insert moulding and the # 1 retaining tab or between the # 1 retaining tab and other retaining tabs, Figure 1.

ACTION: Rework the existing bumper insert moulding or, if required, install new bumper insert mouldings. Refer to the following procedure for service details.