Front Seat Back Foam Pad - Visible At Seat Pivot
90ford38 Article No. 90-19-7SEAT - FRONT - BACK FOAM PAD IS VISIBLE ABOVE SEAT PIVOT POINT
LINCOLN-MERCURY: 1991 CAPRI
ISSUE: The front seat back foam pad may show below the seat trim at the inner pivot of the seat. This occurs because the foam was not trimmed properly.
ACTION: Trim the visible part of the seat foam pad. Refer to the following procedure for service details.
1. Roll the seat trim material upward from the seat frame as far as possible, without straining the trim material.
2. Use a sharp cutting blade to carefully remove the visible areas of the seat foam pad.
3. Put the seat trim material back to its original position.
4. Make sure the seat foam pad is not visible.
5. If required, repeat the procedure for the opposite side seat.
OTHER APPLICABLE ARTICLES: None
WARRANTY STATUS: Eligible Under Basic Warranty Coverage
OPERATION DESCRIPTION TIME
901907A Trim Foam Pad - One Or 0.3 Hr.
Both Sides)
DEALER CODING
BASIC PART NO. CONDITION CODE
7064810 35
OASIS CODES: 101000, 107000