Wagon

Removal and Installation
1. Remove rear seat cushion.
2. Remove rear seat back.
3. Remove buckle end anchor nuts and remove buckle end belts.
4. Remove roof side inner rear moulding on driver's or passenger's side.
5. Remove bolt in sling assembly.
6. Remove quarter trim panel.
7. Remove safety belt anchor-to-sill bolt.
8. Remove safety belt through slot near sill.
9. Snap out bezel in quarter trim panel.
10. Remove safety belt assembly through bezel opening.
11. Remove safety belt retractor bolt.
12. Remove outboard safety belt assembly from vehicle.
13. Repeat procedure on opposite side.
14. To install, reverse Steps 1 through 13.

NOTE: Be sure to tighten all retaining bolts to specification during installation.