Removal

1. Raise and support vehicle.
2. Remove wheel and tire assembly.
3. Remove caliper. Service and Repair
4. Remove rotor from hub assembly by pulling it off the hub studs.

TIP: If additional force is required to remove rotor, apply Rust Penetrator D7AZ-19A501-A or equivalent on front and rear rotor/hub mating surfaces. First, strike rotor between studs with a plastic hammer. If this does not work then attach 3-Jaw Puller D80L-1013-A or equivalent and remove rotor.

NOTICE: If excessive force must be used during rotor removal, the rotor should be checked for lateral runout prior to installation.