Suspension Control Module: Service and Repair

Do not replace any system component without first performing the system diagnosis procedures. Replacement of satisfactory components may result.

Sedan Models

1. Disconnect battery ground cable.
2. Remove RH luggage compartment side trim panel.
3. Disconnect module wiring connector by pushing inward on retainer and pulling up.
4. Remove two attaching bolts.
5. Remove module.
6. Remove U-nuts from module.
7. Reverse procedure to install. Torque attaching bolts to 6-13 ft. lbs.

Station Wagon Models

1. Disconnect battery ground cable.
2. Remove RH rear side trim panel (spare tire cover).
3. Disconnect module wiring connector by pushing inward on connector retainer (back side of connector) and pulling downward.
4. Remove two attaching bolts.
5. Remove module.
6. Reverse procedure to install. Torque attaching bolts to 6-13 ft. lbs.