Rear Door Panel: Service and Repair

Rear Door:

Removal and Installation

1. Snap out two door pull strap retainer screw covers. Remove screws.

2. Remove one screw from lower rear door panel.

3. Remove screw retaining rear inside door handle cup. Remove rear door inside handle cup.

4. Using the Trim Pad Removing Tool from Rotunda Molding Trim Kit 10700401 or equivalent, pry trim panel retaining clips from rear door inner panel.

5. Disconnect any electrical connection from switches, if equipped, and remove rear door trim panel.

6. To Install, reverse Removal procedure.