Front Door Panel: Service and Repair

The following procedure must be used during removal and installation of the door armrest and trim panel. Refer to the appropriate illustrations for component and vehicle model identification.

Front Door:

Removal

CAUTION:
To avoid breakage of door pull cover(s), insert a screwdriver diagonally between pull strap, and chrome bracket. Snap out both sides then remove.

1. Snap out two door pull strap retaining screw covers. Remove screws.

2. Remove two screws on front and rear side of door trim panel.

3. Using the Trim Pad Removing Tool from Rotunda Moulding/Trim Kit 107-00401 or equivalent, pry the trim panel retaining clips from the door inner panel.

NOTE:
Do not use trim panel to remove trim clips from door inner panel. Replace any bent, damaged or missing push pins.

4. Remove window regulator switch housing from back of trim panel. Lift up housing and disconnect all connectors.

5. Disconnect driver seat memory seat switch (driver's door only) if so equipped.

6. Twist out courtesy lamp wire assembly.


Installation

1. Ensure plastic watershield is secured to door panel.

2. Position trim panel to door. Connect courtesy lamp wiring.

3. Align door lock side to its mating slide on the sheet metal.

4. Snap in trim panel. Ensure all retainers fit properly.

5. Install two retaining screws on front and rear side of door trim panel.

6. Connect driver seat memory switch (driver's door only) if so equipped.

7. Position window regulator switch housing and connect switch connectors. Install to door trim panel by snapping in.

8. Install two retaining screws and pull strap covers.

9. Install two retaining screws and pull strap covers.