Supercharged

REMOVAL

Fuel Supply Manifold - Supercharged:

1. Disconnect battery ground cable and secure it out of the way.
2. Release pressure from fuel system.
3. Remove supercharger and throttle body.
4. Using a spring lock coupling remover, disconnect the crossover fuel hose from the fuel rail assembly.
5. Remove four fuel rail assembly retaining bolts (two on each side).
6. Carefully disengage fuel rail from fuel injectors and remove fuel rail.
NOTE: It may be easier to remove injectors with the fuel rail as an assembly.
7. Using a rocking, side to side motion while liting to remove injectors from fuel rail.

INSTALLATION

1. Ensure injector caps are clean and free of contamination.
2. Place the fuel injector fuel rail assembly over each of the injectors into the fuel rail. Ensure injectors are well seated in the fuel rail assembly.
NOTE: It may be easier to seat the injectors in the fuel rail and then seat the entire assembly in the lower intake manifold.
3. Secure the fuel rail assembly using four retaining bolts. Tighten to 70-97 lb. in. (8-11 N-m).
4. Install supercharger and throttle body.
5. Connect fuel inlet and outlet lines to fuel fuel rail assembly.
6. Firmly push and pull the fuel inlet and outlet lines to ensure that they are positively locked to the fuel rail connectors.