Rear

1. Position vehicle on a level surface.
2. Turn ignition switch to Off or LOCK position.
3. Remove luggage compartment side trim panel.
4. Disconnect actuator electrical connector from harness connector.
5. Depress actuator attaching tabs, then remove actuator.
6. Grasp mounting bracket using a suitable tool.
7. While holding mounting bracket, loosen bracket attaching nut.
8. Remove mounting bracket.

CAUTION: Do not attempt to raise vehicle after nut is removed. If shock absorber is to be removed, install mounting bracket retaining nut.

9. Reverse procedure to install, ensuring flat of shock absorber piston rods aligns with mounting bracket. Torque mounting bracket nut to 27-35 ft lb.