Rear

LOWER ARM

1. Remove coil spring as described in COIL SPRING.
2. Remove inner control arm pivot bolts and nuts, then remove arm assembly.
3. Remove toe compensating link from control arm.
4. Reverse procedure to install. Tighten to specifications.

UPPER ARM

1. Raise and support vehicle.
2. Remove rear wheel and tire assembly.
3. Support knuckle and hub assembly so that it cannot swing outward.
4. Remove inner and outer pivot bolts and nuts at upper control arm, then remove upper control arm.
5. Reverse procedure to install, noting that inner pivot bolt used for camber adjustment has a specially-shaped washer under bolt head. Ensure fasteners are used in correct locations. Set camber adjustment as described in ADJUSTMENT PROCEDURES/WHEEL ALIGNMENT. Tighten to specifications.