Rear

REMOVAL and INSTALLATION
1. Remove rear seat cushion.
2. Remove rear seat back.
3. Remove buckle end anchor nuts and remove buckle end belts.
4. Remove upper and lower quarter trim panels.
5. Remove safety belt anchor-to-sill bolt.
6. Remove pushpin retaining rear seat belt retractor cover assembly.
7. Remove retractor anchor bolt and retractor screw.
8. Remove anchor end of webbing through the opening in the quarter trim panel.
9. Remove outboard safety belt assembly from the vehicle.
10. Repeat procedure on opposite side.
11. To install, reverse Steps 1 through 10.

NOTE: Be sure to tighten all retaining bolts to specification.