Initial Installation Adjustment

1. Install parking brake control (hand or foot) tensioner and all cables with routing clips. Connect all cables together with tensioner.

NOTE: Be sure to install correct adjuster for rear brake usage.

2. Place the transmission in NEUTRAL (N). Raise the vehicle on an axle-type hoist.
3. With parking brake control in the OFF position, release tensioner by ROTATING locking lever AWAY from threaded rod. Tensioner spring will take up cable slack and preload cables.

NOTE: DO NOT PULL DOWN on locking lever or it will pull cables down and cause the cables to have low tension.

NOTE: Lock tensioner by releasing locking lever. Ensure locking lever is secure by ROTATING it TOWARD threaded rod.

4. Apply parking brake control fully on 445 N (100 lbs) foot pedal effort, 334 N (75 lbs) hand effort. Release parking brake control. Repeat application and release.
5. Repeat Step 3 to take up any additional slack.