Left Front

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY AND BACKUP POWER SUPPLY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE AND BACKUP POWER SUPPLY MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect battery ground cable and backup power supply.
2. Remove washer fluid reservoir.
3. Disconnect LH front sensor electrical connector and wiring retainer.
4. Remove screws retaining LH front sensor to LH fender apron and remove sensor from vehicle.

Installation
1. Position LH sensor to LH fender apron and secure with retaining screws. Tighten screws to 4-5 Nm (35-44 lb-in).
2. Connect LH front sensor electrical wiring connector to wiring assembly connector and secure wiring retainer.
3. Install washer fluid reservoir.
4. Connect backup power supply and battery ground cable.
5. Verify air bag indicator lamp.