Front Center Sensor

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect battery ground cable.
2. Remove air induction resonator.
3. Disconnect center front sensor electrical connector.





4. Remove three screws attaching center front sensor to radiator support. Remove sensor from vehicle.

Installation
1. Position front center sensor with arrow on top pointing toward front of vehicle and secure to radiator support with three screws. Tighten screws to 3.3-4.5 Nm (29-40 lb-in).
2. Connect front center sensor wire lead connector to wiring assembly connector.
3. Install air induction resonator.
4. Connect battery ground cable.
5. Verify air bag indicator lamp.