Left Front

Removal

WARNING: THE ELECTRICAL CIRCUIT NECESSARY FOR SYSTEM DEPLOYMENT IS POWERED DIRECTLY FROM THE BATTERY. TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BATTERY GROUND CABLE MUST BE DISCONNECTED PRIOR TO SERVICING OR REPLACING ANY SYSTEM COMPONENTS.

1. Disconnect battery ground cable.
2. Remove inner tender splash shield.
3. Remove locator on connector from sheet metal.





4. Disconnect LH front sensor electrical connector.
5. Remove two screws attaching LH front sensor to LH fender apron and remove sensor from vehicle.

Installation
1. Position LH sensor to LH fender apron and secure with two screws. Tighten screws to 9-14 Nm (7-10 lb-ft).
2. Connect LH front sensor electrical wiring connector to wiring assembly connector.
3. Install locator on connector into hole in sheet metal.
4. Install inner fender splash shield.
5. Connect battery ground cable.
6. Verify air bag indicator lamp.