Belt Replacement Without Anchor Plate Thread Damage

1. Remove damaged bolt from anchor reinforcement and discard.
2. Install a new bolt. Tighten to 30-43 Nm (22-32 lb-ft).
3. Install attachment parts in proper sequence. Tighten replacement bolt to specifications. Original parts are to be replaced with specified service parts.

Before installing the new safety belt assembly, safety belt attaching areas must be inspected for damage and distortion. If the attaching points are damaged and distorted, the sheet metal must be worked back to its original shape and structural integrity.

Install new safety belt(s) using the appropriate instructions. Perform Functional Test Procedure. Testing and Inspection