Rear Safety Belt Assembly

REMOVAL

Special Tool
Seat Belt Bolt Bit T77L-2100A or equivalent

1. Remove rear seat cushion.
2. Remove buckle end anchor nuts and remove buckle end belts.
3. Remove rear seat back.
4. Remove attaching bolt to both rear seat retractors. Remove retractors.

NOTE: When only the outboard or center safety belt assembly is replaced, the brass ring holding one anchor of the center safety belt assembly and the buckle end anchor of the outboard safety belt must be pried open and discarded in order to slide belt anchor out of assembly.

INSTALLATION
1. Reverse removal procedure, being sure to position belts and retractor as shown. When only outboard or center safety belt assembly is replaced, slide replacement belt into boot until anchors align.
2. Tighten all attaching bolts to 30-43 N.m (22-32 lb-ft). Cycle system several times to ensure proper operation of retractor. Make sure webbing is not twisted.