Fuel Injector Harness

REMOVAL

NOTE: Ensure ignition switch is in OFF position and fuel system is depressurized.

1. Disconnect the electrical connectors from fuel injectors.
2. Disconnect connectors from main wiring harness and throttle position sensor, ACT sensor and Air Bypass Valve.
3. Remove wiring assembly.

INSTALLATION

1. Position wiring harness along side fuel injectors.
2. Snap electrical connectors into position on injectors.
3. Connect Throttle Position Sensor, ACT sensor, Air Bypass Valve and main harness connectors.
4. Verify that all electrical connectors are firmly seated.
5. Use EEC self test connector and procedure to check for sensor function.