Interior Trim Removal

(Refer to Figures 3 and 4)

1. Remove the safety belt D-ring cover.

2. Using Seat Belt Bolt Bit No. T77L-2100-A, or equivalent, remove the bolt retaining the safety belt and D-ring to the "B" pillar assembly.

3. Remove the rear screw retaining the door scuff plate to the floor sill.

4. Remove the two (2) screws retaining the lower quarter trim panel to the body quarter side assembly and remove the panel.

5. Remove the quarter trim finish panel and rear speaker cover assembly. (The speaker cover is retained by locator tabs at the top and snap-on type fasteners at the bottom.)

6. Remove the four (4) screws retaining the rear speaker to the body and remove the rear speaker.

7. Remove the two (2) screws retaining the upper quarter trim panel to the body.

8. Remove the coat hook attaching screw and the coat hook.

9. Remove the front seat shoulder strap guide bezel.

10. Disengage the quarter trim panel.

11. Disconnect the electrical wiring connector from the rear courtesy lamp.