Interior Trim Installation

(Refer To Figures 3 and 5)

1. Connect the electrical wiring connector to the rear courtesy lamp.

2. Install the quarter trim panel.

3. Install the front seat shoulder strap guide bezel.

4. Install the coat hook and attaching screw.

5. Install the two (2) screws retaining the upper quarter trim panel to the body.

6. Connect the electrical connector to the speaker.

7. Install the rear speaker to the body using the (4) retaining screws removed in Step 6 of the Interior Trim Removal Procedure.

8. Snap on the quarter trim finish panel and rear speaker cover assembly.

9. Install the lower quarter trim panel to the body quarter side assembly, using the two (2) screws removed in Step 4 of the Interior Trim Removal Procedure.

10. Install the door scuff plate to the floor sill using the screw removed in Step 3 of the Interior Trim Removal Procedure.

11. Position the D-ring to the "B" pillar. Make sure the belt webbing is not twisted.

12. Using Sear Belt Bolt Bit No. T77L-2100-A, or equivalent, install the bolt retaining the safety bolt and D-ring to the "B" pillar assembly. Torque the bolt to 30-43 No-m (22-32 Lb.-Ft.).

13. Make sure the belt webbing is not twisted. Install the lower bolt retaining the safety belt anchor to the floor sill assembly. Torque the bolt to 30-43 No-m (22-32 Lb.-Ft.).

14. Install the safety belt D-ring cover.