Removal

Except for manifold hose O-rings and front shaft seal this compressor is not serviceable and must be replaced as an assembly.
1. Drain oil from compressor through manifold openings.
2. Clamp compressor in suitable vise, then remove clutch assembly.
3. Remove snap ring using suitable tool and clutch field coil from front of compressor.
4. Remove felt and retainer from front of compressor.





5. Place shaft seal remover tool T89P-19623-BH or equivalent over compressor shaft and push tool into nose of compressor and down against shaft seal, Fig. 23. Engage end of tool with internal diameter of shaft seal and turn handle clockwise to expand tool tip inside seal inner radius, then remove seal.