Safety Belt and Retractor Assembly Installation

(Refer To Figures 3 and 5)

1. Install the safety belt and retractor assembly. Make sure the belt webbing is not twisted.

2. Install the bolt retaining the safety belt retractor assembly to the "B" pillar assembly. Torque the bolt to 30-43 N-m (22-32 Lb.-Ft.).





3. Install the plug button (included in the kit) into the opening in the "B" pillar. Refer to Figure 5, View B.

NOTE:
Prior to installation wipe clean the outer surface area surrounding the hole.

4. Slide the safety belt through the slot in the upper trim panel.