Fuel Pump Relay: Testing and Inspection

Fig. 14 Fuel pump relay terminal identification:

The fuel pump relay is located in the circuit protection panel which is in the cowl near the left rear corner of the engine compartment.
1. Remove fuel pump relay from circuit protection panel.
2. Connect an ohmmeter between terminals 85 and 86 on face of relay, Fig. 14.
3. If ohmmeter reads other than 85 ohms, replace relay.
4. Connect jumper wire from alternator output terminal to relay terminal 86 and another jumper wire from relay terminal 85 to a clean chassis ground.
5. If relay does not click when ground connection is made and/or ohmmeter does not show continuity between relay terminals 85 and 30, replace relay.