Technical Instructions

Technical Instructions

Removal:

1. Remove the glove compartment liner by pressing in on each end of the liner and allowing the glove compartment door to hang by its hinges.

2. Disconnect the wire connector from the blower motor resistor assembly.





3. Remove two (2) resistor attaching screws and remove the resistor assembly (Refer to Illustration).

Installation:

1. Position the new blower motor resistor assembly (Part Number E2FZ-19A706-A) in the opening and install the two (2) attaching screws.

2. Connect the wire harness connector to the resistor assembly.

3. Check for proper operation of the blower motor in all blower speeds.

4. Raise the glove compartment door, while pressing in on each end of the glove compartment liner, until the glove compartment liner tabs re-engage.