RH Front Door Window Switch

Removal and Installation
High Series (Low Series shown below)






Note: Image shows LH Front door housing - RH similar.

1. Remove the screw from the front end of the bezel and lift the bezel and switch away from the armrest.
2. Remove the bezel and nut from the mirror remote control (left front door only).
3. Remove two nuts from the bezel studs and separate the switch(es) from the bezel.
4. Pull the switch from the switch connector.
5. To install, position the switch to the connector and press together firmly.
6. Position the switch(es) to the bezel and install the two retaining nuts.
7. Install the bezel and.nut on the outside mirror remote control.
8. Position the switch and bezel to the arm rest and install the retaining screw.

Removal and Installation
Low Series Master Switch

Figure 8 - Power Window Switches:

1. For the 4-door model the master switch and bezel is an integral unit. Remove the retaining screw from the bottom side of the unit (Fig. 8). Then pivot the lower edge of the unit out and remove the unit. To remove the connector carefully pry the unit from the connector with a small screwdriver.
2. To install reverse the process.
3. The 2-door model uses two single switches as the master switch, to remove the single switch(es), remove the switch bezel retaining screw from the bottom side of the switch (Fig. 8). Then, pivot the lower edge of the bezel out and up to remove the bezel.
4. The switch is held in place by the electrical contact pins. To remove the switch, carefully pry the switch from the connector with a small screwdriver.
5. To install, position the switch to the connector and press firmly into place.
6. Install the bezel on the switch and install the bezel retaining screw.
7. Install the bezel switch in the vehicle.