Attachment III - Technical Instructions

1. Remove the two screws retaining the decorative seat back latch cover. (Refer to figure 1)

2. Remove and discard the two lower screws from the seat cushion.

3. Install the two new replacement screws (N804850-S2) and hand torque to 30-35 N-m (22-26 ft.lbs.)

NOTE:
If the seat cushion frame extrusion should strip when torquing, install an M10 nut (N620482-S2) and hand torque the screw and nut to 44-60 N-m (33-44 ft. lbs.)

4. Reinstall the decorative seat back latch cover using the original attaching screws.