Campaign - Software Calibration Number Code-Front SAM

Campaign No. 2012120001, December 2012

TO: ALL MERCEDES-BENZ CENTERS

SUBJECT: Model X204. Model Year 2013

Software Calibration Number (SCN) Code - Front SAM

This Service Campaign has been initiated because Daimler AG (DAG), the manufacturer of Mercedes-Benz vehicles, has determined that the parking lamps may be too bright in the subject vehicles. Dealers will update the SCN code in the front SAM to correct this condition at the next workshop visit

Prior to performing this Service Campaign:

^ Please check VMI to determine if the vehicle is involved in the Campaign and if it has been previously repaired.

^ Please review the entire Service Campaign bulletin and follow the repair procedure exactly as described.

Please note that Recall and Service Campaigns do not expire and may also be performed on a vehicle with a vehicle status indicator.

Approximately 2,950 vehicles are affected.

Procedure

Note:
^ Use Xentry 11/12 with all associated patches or higher.

^ Follow the steps exactly as described in Xentry.

^ Connect battery charger (battery voltage >12.5V).

1. Connect Star Diagnosis to vehicle.

2. SCN code SAM-F control module: Control unit / Adaptations / SCN coding.

3. Follow on-screen instructions.

Note:
The following allowable labor operation should be used when submitting a warranty claim for this repair:





Warranty Information