AR35.10-P-0050-02V Remove/Install Rear Rubber Mounts of Rear Axle Center Assembly Mount

AR35.10-P-0050-02V Remove/install rear rubber mounts of rear axle center assembly mount

Special Tools:

Workshop Equipment:

Component Identification:

Remove rubber mounts
1 Measure and note press-in depth of inner core of both rubber mounts (62) on rear axle crossmember (8) from the front using depth gauge.

Component Identification:

2 Pull rubber mount (62) forwards out of rear axle carrier (8) using sleeve (15) and thrust piece (16).

Component Identification:

Install rubber mount
3 Rub the circumference of the rubber mount (62) with lubricant.
4 Position rubber mount (62) from the front on the rear axle crossmember and using the thrust piece (5) and sleeve (6) pull into the rear axle carrier (8) until the press-in depth measured previously is attained.