AN54.65-P-0030-02SX Retrofit Camera

AN54.65-P-0030-02SX Retrofit Camera







1. Detach license plate from trunk lid (6).
2. Remove umbrella holder (7).
3. Remove hazard warning triangle (8) and remove bracket (9)
4. Remove cover (10).
5. Remove hinge bracket trim piece (11).
6. Remove trim of trunk lid (12).
7. Unscrew bolts (13) on inside of trunk lid release (14).
8. Unclip clips (16) of cover (15) starting from the right. Detach adhesive tape (17) and remove cover (15).
The cover (15) without cutout for backup camera is no longer required and later on is replaced by a new cover (15) with cutout for backup camera.

Shown: Cover (15) with cutout for backup camera.







9. Remove cap (18) from trunk lid (6).
The cap (18) is no longer required.
10. Insert black 4-pin connector (19) and line branch off (20) of backup camera (B84/3) from outside in the trunk lid cutout and clip backup camera (B84/3) into the trunk lid (6) as per picture (6).
Later on connect black 4-pin connector (19) in the trunk lid (6) with the wiring harness of the backup camera.