P2617

The signal of the position sensor of the crankshaft has an electrical fault or an open circuit. There is an open circuit.
Test signal voltage of component 'B70 (Crankshaft Hall sensor)'.


Connection of socket box
Legend

- A - Connection of test cable of socket box (35-pin)
- 001 - Plug-in connectors of component 'N3/9 (CDI control unit)'
- 003 Adapter cable (63-pin)
- 004 Adapter cable (58-pin)
- 005 Socket box (189-pin)
- 05 - Socket box (35-pin)
- 050 - Socket box (126-pin)
- 108 - Test cable 266 589 01 63 00
- N3/9 (CDI control unit)
- II 1-63 Connection of test cable
- III 64-126 Connection of test cable

Special tools

- Socket box 129 589 00 21 00 (126-pin)
- Socket box 124 589 00 21 00 (35-pin)
- Test cable 266 589 01 63 00
- Socket box 000 589 00 21 00 (189-pin)
- Adapter cable 000 589 00 21 03 (63-pin)
- Adapter cable 000 589 00 21 04 (58-pin)

Test procedure

- Switch off ignition.
- Buchsenkasten an das Steuergerät 'N3/9 (CDI control unit)' anschließen.
- Switch on ignition.

Caution!

- Connection A of test cable 108 must NOT be connected to connection B of the 126-pin socket box.











Test 1: Continue

1.
Test signal voltage of component 'B70 (Crankshaft Hall sensor)'.

- The measured value is OK.

End of test



End of test
Result: Pass