P256885

The PremAir sensor has a malfunction. There is a signal above the permissible limit value.
Check component 'B11/15 (PremAir sensor)'.


Note

- The PremAir sensor must be firmly latched and bonded to the PremAir radiator.



Test 1: Continue

1.
Check fastening and installation position of component 'B11/15 (PremAir sensor)'.
The retainer is OK.
Possible cause and remedy

- Check electrical line for the power supply of component 'B11/15 (PremAir sensor)'.
- Replace PremAir sensor.
- The PremAir sensor must be installed and bonded in the second hole in the PremAir radiator after being turned 180°.

Note

- For warranty processing the control unit log must be submitted when the PremAir sensor is replaced.

End of test


End of test
Result: Pass