P019017

The rail pressure sensor has an electrical fault. The limit value for electrical voltage has been exceeded.
Check component 'B4/25 (Fuel pressure and temperature sensor)' by means of actual value.


Test 1: Continue

1.

Test 1.1: Continue

1.1.

Test 1.1.1: Continue

1.1.1.
Check power supply of component 'B4/25 (Fuel pressure and temperature sensor)'.
Test procedure
Switch off ignition.
Remove air filter of right cylinder bank.
Disconnect 4-pin plug-in connector of component 'B4/25 (Fuel pressure and temperature sensor)'.
Switch on ignition.
[B4/25x1] Measure direct voltage with multimeter between 1 and 4 [B4/25x1]
Specified value
The measured value must be between 4.75V and 5.25V.
Question
Is the measured value OK?







End of test
No successor specified