E1951

Initial startup of control unit in component A80 (Intelligent servo module for DIRECT SELECT) has not yet been performed.


Possible cause:

- A80 (Intelligent servo module for DIRECT SELECT)
Affected functions:

- Drive position selection

-------------------------------------------------

Test 1: Remedial action if initial startup of control unit A80 (Intelligent servo module for DIRECT SELECT) was not performed

1. Remedial action if initial startup of control unit A80 (Intelligent servo module for DIRECT SELECT) was not performed
Operation number of operation texts and work units or standard texts and flat rates:27-0641POSSIBLE CAUSES

- Initial startup of control unit A80 (Intelligent servo module for DIRECT SELECT) was not performed.
REMEDY

- Perform initial startup.
Continue with button "F2"

Initial startup
The following procedure will guide you through all steps required to perform a complete initial startup of system ISM.Preconditions

- The new control unit must have already been installed.
You will be guided through the following steps

- Detach transport protection.
- Perform calibration.
- Personalizing
- Activating
Start process with button F2.

Warning!Communication with ECU required.