Interior Lighting Module: Service and Repair

AN82.10-P-0001-03CW Retrofit Control Unit

Auxiliary Repair Materials:

1 Stick double-sided adhesive tape, width 25 mm, to entire reverse side of illuminated door sill molding control unit (1).

Bonding surfaces must be pre-treated in accordance with adhesive tape manufacturer's instructions.

2.1 Vehicles without electronic transmission control control unit (N15/3):
- Glue on illuminated door sill molding control unit (1) to footrest as per picture and fasten with bolt and nut (see arrow).

Bonding surfaces must be pre-treated in accordance with adhesive tape manufacturer's instructions.

2.2 Vehicles without electronic transmission control unit (N15/3):
- Glue on illuminated door sill molding control unit (1) to electronic transmission control control unit (N15/3).

Bonding surfaces must be pre-treated in accordance with adhesive tape manufacturer's instructions.