Daytime Running Lamp Control Unit: Service and Repair

AZ82.10-P-0020-03CW Retrofit Daytime Running Lights Control Unit






Installation of the right daytime running lights control unit (2.1) and the left daytime running lights control unit is shown here with the bumper removed for better clarity.

1 Position right daytime running lights control unit (2.1), as shown, on right fender liner (29) and drill two holes with a diameter of 6.5 mm corresponding to the fastening points.
Cordless drill/driver
gotis://G_58.0_01.1

2 Tighten right daytime running lights control unit (2.1) using the nuts and screws/bolts (28) included in the parts kit on the right fender liner (29).






3 Position left daytime running lights control unit (2.2), as shown, on left fender liner (29) and drill two holes with a diameter of 6.5 mm corresponding to the fastening points.
Cordless drill/driver
gotis://G_58.0_01.1

4 Tighten left daytime running lights control unit (2.2) using the nuts and screws/bolts (28) included in the parts kit on the left fender liner (29).






5 Connect black 3-pin coupling (5) of daytime running lights wiring harness (7) with black 3-pin connector (6) of right daytime running lights control unit (2.1).
6 Connect black 3-pin coupling (5) of daytime running lights wiring harness (7) with black 3-pin connector (6) of left daytime running lights control unit (2.2).
7 Connect black 2-pin coupling (3) of right daytime running lights headlamp with black 2-pin connector (4) of right daytime running lights control unit (2.1).
8 Connect black 2-pin coupling (3) of left daytime running lights headlamp with black 2-pin connector (4) of left daytime running lights control unit (2.2).