EU140D00

An implausible wheel speed signal was received.


Possible cause:

- N30/4 (Electronic Stability Program control unit)
Affected functions:

- Transmission mode selection
- Drive position selection

-------------------------------------------------

Test 1: Remedial action in the event of implausible signals from control unit N30/4 (Electronic Stability Program control unit)

1. Remedial action in the event of implausible signals from control unit N30/4 (Electronic Stability Program control unit)
Operation number of operation texts and work units or standard texts and flat rates:27-0641WARNING

- This is not a function error of control module N15/3 (ETC [EGS] control unit) and does not justify replacement.
Possible cause for the entry of this event code

- Operational fault of component N30/4 (Electronic Stability Program control unit)
Possible measures

- Read out fault memory of control unit N30/4 (Electronic Stability Program control unit).
- Process displayed fault codes in control module N30/4 (Electronic Stability Program control unit).
End of test