AR35.10-P-0040-03CW Remove/Install Rear Rubber Mount In Rear Axle Mount

AR35.10-P-0040-03CW Remove/install rear rubber mount in rear axle mount

Special Tools:

Repair materials:

Component Identification:

Removing
Always replace rubber mounts (1) in pairs. The following tools are required from the extraction and insertion tools:
thrust piece (01)204 589 00 43 01,
counterholder (02) 204 589 00 43 02,
spindle (05) 204 589 00 43 05 and
Sleeve (012)204 589 00 43 12

1 Mark the installation position of the respective rubber mount (1) at cutout (arrow)
2 attach thrust piece (01), counterholder (02), spindle (05) and sleeve (012) with hollow cylinder (015) and retaining belt (014) to rubber mount (1).
3 Connect hand pump by means of hydraulic hose (013) on hollow cylinder (015).
The retaining belt must be routed behind the thrust piece in order to prevent the hollow cylinder falling down when the rubber mount is pressed out.
4 Press out rear rubber mounts (1) from rear axle carrier (4)

Component Identification:

Install
The following tools are required from the extraction and insertion
tools:
thrust piece (03)204 589 00 43 03,
counterholder (04) 204 589 00 43 04,
spindle (05) 204 589 00 43 05and
Sleeve (012)204 589 00 43 12

5 Coat new rubber mount (1) with antifriction agent.
6 Attach thrust piece (03), counterholder (04), spindle
(05) and sleeve (012) with hollow cylinder (015) and retaining belt (014) to rubber mount (1).
7 Press rubber mount (1) into rear axle carrier (4).