AR35.20-P-0114-01CW Remove/Install Spring Control Arm Rubber Mount

AR35.20-P-0114-01CW Remove/install spring control arm rubber mount

Special Tools:

Component Identification:

Removing
The stroke of the press (010) is very low, because of this the press (010) must be released several times, the spindle (a) of the bracket (01) must be adjusted and the press (010) operated again.
1 Install sleeve (001) on bracket (01).
2 Attach bracket (01) to rear axle carrier (4) and rubber mount (61) using sleeve (001), thrust piece (04) and press (010).
3 Press rubber mount (61) out of rear axle carrier (4).

Component Identification:

Install
4 Install sleeve (02) on bracket (01).
5 Attach bracket (01) to rear axle carrier (4) and rubber mount (61) using sleeve (02), thrust piece (07) and press (010).
6 Press rubber mount (61) into rear axle carrier (4).