AR40.20-P-0322-01CW Install Repair Bolt

AR40.20-P-0322-01CW Install repair bolt

Camber adjustments:

Camber and caster adjustments:

Component Identification:

1 Jack up vehicle at the front (the suspension must be fully rebounded).
2 Remove series bolt (19a) with nut (19b) on cross strut (17).
For camber correction.

Component Identification:

3 Remove series bolt (19a) with nut (19b) on torque strut (18).
For caster correction.

Component Identification:

4 To adjust camber and caster, replace the respective standard bolt (19a) on the torque strut (18) or cross strut (17) with a repair bolt (19c).
A Standard threaded connection
B Repair threaded connection

Component Identification:

The standard bolt (19a) is centered by the bumps (arrows) in the bearing of the torque strut (18) or cross strut (17). Grooves in the repair bolt (19c) permit it to be installed into the rubber mount on either the right or left side, allowing the torque strut (18) or cross strut (17) to be adjusted by a distance of 4 mm to the inside or outside.
The repair bolt (19c) must not be rotated after being fixed into place in the rubber mount of the strut rod (18) or the cross strut (17). Do not tighten the nut (19b) yet so that the rubber mount of the strut rod (18) or cross strut (17) can twist when the vehicle is rocked to settle the suspension.