GF91.25-P-0001FL Multicontour Seat (MCS), Function

GF91.25-P-0001FL Multicontour Seat (MCS), Function
- with CODE (409) Left/right front multicontour seats

Function requirements, general
^ Circuit 15 or circuit 15R ON
^ No overvoltage or undervoltage
^ No damage to the compressed air supply.

Function description of multicontour seat, general
The multicontour seat pneumatic pump (M40) is supplied with voltage by the rear SAM control unit with fuse and relay module (N10/2).

The multicontour seat can be adjusted individually. The individual adjustment of the contour and the surface hardness of the backrest and of the seat cushion is made possible by filling and purging.

The air cushions are located as follows:
- in right and left lumbar support area,
- in upper lumbar support area,
- in lower lumbar support area and
- in front upper leg area on seat cushion (except code (494) USA version, passenger side).

Lumbar support = curvature of spine in lumbar region.

The inflating and deflating of the individual air cushions is controlled manually via the:
- Seat cushion fore/aft adjustment (except code (494) USA version, passenger side)
- Control valve for lower lumbar support adjustment)
- Control valve for upper lumbar support valve adjustment
- Control valve for side bolsters adjustment

located in the:
- Control valve block for multicontour seat

The multicontour seat enables the following subfunctions to be performed:
^ Seat cushion length adjustment (except code (494) USA version, passenger side)
^ Adjustment of the lower lumbar support area
^ Adjusting upper lumbar support area
^ Adjustment of the lateral support

Adjustment of seat cushion length (except code (494) USA version, passenger side)
The front area of the multicontour seat cushion is adjusted using the control valve for seat cushion fore/aft adjustment.

When actuating the control valve for seat cushion fore/aft adjustment in the (>) or (<) direction, the seat cushion contour changes in the upper leg area by inflating or deflating the air cushion.

Adjustment of the lower lumbar support area
The lower lumbar support area of the multicontour backrest is adjusted using the control valve for lower lumbar support adjustment.

When actuating the lower lumbar support adjustment control valve in direction (>) or (<) the backrest contour in the lower lumbar support area is changed by inflating or deflating the air cushion.

Adjusting upper lumbar support area
The air cushion in the upper lumbar support area of the multicontour backrest is adjusted with the control valve for upper lumbar support adjustment.

When actuating the upper lumbar support adjustment control valve in direction (>) or (<) the backrest contour in the upper lumbar support area is changed by inflating or deflating the air cushion.

Adjustment of the lateral support
The lateral support of the multicontour backrest is adjusted using the control valve for side bolsters adjustment.

When actuating the control valve for side bolsters adjustment in the (><) or (<>) direction, the air cushions of the left and right side bolsters of the multicontour backrest are inflated or deflated.