AZ82.60-P-0015-07EWA Make Cutout For Bracket

AZ82.60-P-0015-07EWA Make Cutout For Bracket
- MODEL 212.0## /2##, 218.3## 1#

The following operation steps are shown on the right side of the vehicle and can be accomplished analogously on the left side of the vehicle.






1 Cut out cutting template (11) along broken line.
The cutting template (11) is included in the installation kit.






2 Apply cutting template (11) to head restraint and mark separating point (broken line).
3 Remove cutting template (11).






4 Cut seat cover using a knife and fix shackle (12) in place using adhesive tape (13).
Be very careful while cutting, otherwise the seat cover may be damaged.

5 Work out opening in seat cover and remove remaining foam.
Be very careful while cutting, otherwise the seat cover may be damaged.

6 Work out seat core until cross strut (14) of seat is accessible.
Be very careful while cutting, otherwise the seat cover may be damaged.

7 Fold shackle (12) into opening.