EP179C64

Control unit 'DIRECT SELECT' has a malfunction. There is a component fault.


Affected functions:

- Drive position selection

-------------------------------------------------

Test 1: Remedial action if control unit is faulty 'A80 (Intelligent servo module for DIRECT SELECT)'

1. Remedial action if control unit is faulty 'A80 (Intelligent servo module for DIRECT SELECT)'
Operation number of operation texts and work units or standard texts and flat rates:27-0641Warning!

- This is not a function error of control module A80 (Intelligent servo module for DIRECT SELECT) and does not justify replacement.
Possible cause if fault code P179C64 is stored

- Calibration was not successfully carried out.
- The power consumption of component 'A80 (Intelligent servo module for DIRECT SELECT)' is too high.
Possible remedy

- Connect charging equipment.
- Switch off all consumers.
- Perform calibration again.
End of test