13AB00

The supply voltage of control unit N3/9 (CDI control unit) is too low (undervoltage).


Possible cause:

- Supply voltage
Affected functions:

- Power generation

-------------------------------------------------

Test 1: Check component Power supply.

1. Check component Power supply.
Power supply Terminal (87)
Test prerequisite

- The actual value is not o.k.
Test sequence

- Check voltage supply at fuses 101, 103 and 105.
- Measure direct voltage with multimeter between ground socket and socket F58f101 (Fuse 101)
- Measure direct voltage with multimeter between ground socket and socket F58f103 (Fuse 103)
- Measure direct voltage with multimeter between ground socket and socket F58f105 (Fuse 105)
- Switch on ignition.
Specified value

- Voltage[11...14] V
Question

- Is the measurement value OK?


YES
The measurement value is OK.Possible cause and remedy

- In the fault freeze frame data, check whether the power supply was OK at the time the fault occurred.
Battery voltage < 8 V Ignore fault code and erase fault memory.Battery voltage >= 8 V Replace control module N3/9 (CDI control unit).End of test

NO
The measurement value is not OK.Possible cause and remedy

- Check component F58kD (Engine circuit 87 relay).
- Test wiring from component N3/9 (CDI control unit) to component F58 (Engine compartment fuse and relay box) with an ohmmeter for short circuit (positive or negative) and repair, if necessary.
End of test